Welcome to Xianju Hongtai Pump Co., Ltd.
28
2024
-
05
How to use the high viscosity rotor pump correctly?
High viscosity rotor pump is a new type of positive displacement pump developed according to the needs of petroleum, chemical industry, coating, grease, medicine, dye, food and other industries. Because the product can be made of different materials and its structure, it is widely used in different nature and viscosity medium transportation. High viscosity rotor pump if the occasional occurrence of insufficient flushing fluid or interruption of the phenomenon, the one-way valve will automatically close. The friction ring carries the load of the fluid at the end of the medium, thereby cutting off the sealed medium from entering the seal cavity, thus providing protection for the seal.
1, high viscosity rotor pump using the specified voltage, line voltage does not exceed the pumping pump nameplate on the voltage of plus or minus one-tenth can be used.
2. After unpacking the high-viscosity rotor pump, connect the motor, and connect the motor closely to make the pump body and the motor as a whole, and connect the water outlet wheel pipe.
3. Before using the high viscosity rotor pump, check the appearance of each part in good condition before starting up.
4. The high-viscosity rotor pump should not be used for idle operation. When in use, the pump will be stopped after the suction is completed, otherwise it will accelerate the wear of the impeller seals and bearings. Pump tubing may also be worn.
5, high viscosity rotor pump timely replacement brush, brush wear will not be able to use, must be replaced in time (2 brush at the same time replacement) otherwise it will make brush and commutator bad contact caused by damage, damage commutator, serious will burn out the armature.
6, high viscosity rotor pump in the following circumstances shall not be used, in the use of the process if found insulation damage, power cord cable sheath rupture, plug and socket cracking or poor contact, and intermittent operation, sparks and other failures, the motor shell operation, should be repaired immediately. Do not use until repaired.
7, high viscosity rotor pump to prevent overload, when in use, when the speed is abnormal or reduced, should be stopped to check whether there is debris stuck impeller or motor failure, pumping pump for some reason when the brake need to immediately cut off the power supply.
8, high viscosity rotor pump use tools to cherish, all pumping pump should be carefully placed to avoid impact.
High viscosity rotor pump is to transport fluid or make fluid pressurized machinery. It transfers the mechanical energy of the prime mover or other external energy to the liquid, increasing the energy of the liquid. High viscosity rotor pump is mainly composed of gear, shaft, pump body, stable valve and shaft end seal. The rotor has high hardness and strength after heat treatment, and is installed in a replaceable sleeve with the shaft to run. The lubrication of all parts in the pump is automatically achieved by using the output medium when the pump is working. The pump has a reasonably designed oil drain and oil return groove, which is the small torque force that the gear bears during work, so the bearing load is small, the wear is small, and the pump speed is high. The pump is equipped with a control valve as overload protection. The total return pressure of the stabilizing valve is 1.5 times of the rated discharge pressure of the pump, and it can also be adjusted according to actual needs within the allowable discharge pressure range. But pay attention to the control valve can not be used for long-term work, if necessary, can be installed in the pipeline.
National unified service hotline
No.6 -2 Fengxi East Road, Yongan Industrial Agglomeration Zone, Fuying Street, Xianju County
Copyright©Xianju County Hongtai Pump Co., Ltd. Technical Statement